ok in order to make a compressed air potatoe gun your going to need about $25-$30 depending on where you go to buy the following-6 feet of 1'1/2 pvc pipe-1 1'1/2 pvc end cap-1 1'1/2 pvc ball valve-pvc primer-pvc cement-one tire valve (off bike tire)
1. after you have all of the following take the pvc and cut it into 2 sections. one of the sections being 2 feet and the other being obviously 4 feet.
2. after that make a mark on the 2 foot section about 1'1/4 from the end of the tube. drill a hole on your mark the same size as your tire valve stem.
3. prime the valve stem and the pvc, and then cement it. pushing the stem thru the opening from the inside of the pvc. hold for 45 seconds to let set
4. prime/cement the end cap on the same end of the pvc (2 foot section) that the valve is on.
5. on the other side of the 2 foot segment prime, and cement the ball valve on.
6. prime, and cement the 4 foot section to the other side of the ball valve.
7. let set over night (so you wont have leaks if you did it right)
8. fill the 2 foot segment with as much air as you want, turn ball valves handle and enjoy!
picture is on link
http://i31.photobucket.com/albums/c388/snitzeldwarf/airgun.jpg
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment